Flow and Return Piping Systems in Revit MEP

I have been using and provide Revit MEP training for over 10years, and for most of that time when asked if it can create a flow and return piping system my answer has been no.

Contemplate a closed loop system made up of a boiler, a pump and several radiators. Revit will see this as 2 separate systems that would require a flow rate to be added to both the flow and return side of each radiator. As such we have two separate systems, and two sets of Mechanical Flow information where in reality this is a single flow and return system.

If the flow rates were to be removed or altered on either the flow side or the return side of 1 or more of the radiators, there would be either no data or inconsistent data when interrogating the system pipework. Referring to the first image below the flow rate has been removed from the return side of all radiators resulting in no values for that half of the system, but if we look at the flow side in the second image there is Mechanical Flow data.

Closed Loop Systems

The issue of treating this arrangement as a single flow and return systems in Revit MEP can be addressed using the Hydronics Networks feature, which was introduced in the 2018 release of Revit MEP. In the below image we see the option in Mechanical Settings to utilise the feature.

There are 2simple steps you need to take:

1. Set the system’s pump Classification to Pump in the family editor and load it back into your project.

2. From Mechanical Settings enable the option shown below.

What does our flow and return system look like now?

If we interrogate the same section of pipe as before we see that even though there is no flow rate value added to the return side of the radiator there is Mechanical Flow data in the properties.

If we look at the pump properties, we will see additional values for Calculated Flow and Calculated Pressure Drop for the complete flow and return system. Properties that were previously unavailable, without creating a pipe pressure loss report and adding the values together. 

Using this feature allows you to interrogate values in your flow and return system without the need for creating reports and adding values together repeatedly. It also means that you will not have to apply separate values to both the flow and return sides of your radiators (or whatever is in your closed loop system).

To learn more about Revit or Revit MEP, join us in one of our Revit training courses. During these courses you will have direct access to our trainers who will advise you of the best way to use the software, in the most efficient ways. View our website for a full list of available Revit training courses here.

Alternatively contact us directly and we willbe happy to discuss your specific needs with a bespoke Revit training course.